Hyundai Sonata: Front Bumper. Repair procedures - Bumper - Body (Interior and Exterior)Hyundai Sonata: Front Bumper. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
•
Take care not bend or scratch the cover and other parts.
1.
Remove the mounting clips.
2.
Remove the radiator upper cover mounting clips.
3.
After loosening the front bumper side’s mounting screw, then disconnect the side’s.
4.
Remove the front bumper after pull out the front bumper.
•
When you pull out the front bumper, the font bumper could be damaged by the projection (A).

5.
Disconnect the connector (A).
6.
Installation is the reverse of removal.

    Front Bumper. Components and Components Location
    Components 1. Front bumper cover 2. Energy absorber 3. Front bumper rail ...

    Rear Bumper. Components and Components Location
    Components 1. Rear bumper cover 2. Energy up sober 3. Rear bumper side bracket ...

    See also:

    Fuel Filler Door Release Actuator. Repair procedures
    Inspection 1. Remove the trunk room left side trim. (Refer to the BD group - "Interior trim") 2. Open the fuel filler door an ...

    Checking the amount of air conditioner refrigerant and compressor lubricant
    When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative influence on the air conditioning system. Therefore, if abnormal operation ...

    Glove box lamp
    The glove box lamp comes on when the glove box is opened. CAUTION To prevent unnecessary charging system drain, close the glove box securely after using the glove box. ...