Hyundai Sonata: Oil Pressure Switch. Repair procedures - Lubrication System - Engine Mechanical SystemHyundai Sonata: Oil Pressure Switch. Repair procedures

Inspection

1.
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
2.
Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch.
3.
If there is no continuity when a 50kPa (0.50kgf/cm², 7.25psi) is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken. Replace it.

    Oil Cooler. Repair procedures
    Removal 1. Loosen the drain plug, and drain the coolant. Remove the radiator cap to speed draining. 2. Disconnect the oil cooler coolant h ...

    See also:

    Seat Heater Switch. Schematic Diagrams
    Circuit Diagram ...

    Fuel requirements
    Your new vehicle is designed to use only unleaded fuel having a pump octane number ((R+M)/2) of 87 (Research Octane Number 91) or higher. Your new vehicle is designed to obtain maximum performance ...

    Pre-tensioner seat belt
    Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts. The purpose of the pre-tensioner is to make sure that the seat belts fit tightly against the occupa ...