Hyundai Sonata: Power Window Motor. Repair procedures
Inspection
1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
2. |
Disconnect the connector from the motor.
|
3. |
Connect the motor terminals No.2 and No.3 directly to battery
voltage (12V) and check that the motor operates smoothly.
If the operation is abnormal, replace the motor.
[Safety Power Window]
|
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
2. |
Disconnect the 2P connector from the motor.
|
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Power Window Motor. Schematic Diagrams
Circuit Diagram ...Power Window Switch. Schematic Diagrams
Circuit Diagram Driver Power Window Switch Passenger Power Window Switch Rear Power Window Switch ...See also:
Yaw-rate and Lateral G Sensor. Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the floor console.
3.
...
Special Service Tools
Special tools
Tool(Number and Name)
Illustration
Use
09495-33000
Puller
Removal of spider assembly from a drive sha ...
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is
blown, you must reset your sunroof system as follows:
1. Turn the ignition switch to the ON position and close the sun ...