Hyundai Sonata: Seat Track Position Sensor (STPS). Repair procedures
Removal
| 1. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
| 2. |
Remove the front seat assembly. (Refer to BD group)
|
| 3. |
Loosen the two STPS screws, then remove the STPS after disconnecting
the STPS connector.
|
Installation
Be sure to install the harness wires so they will not pinch or
interfere with other parts.
|
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
| 3. |
Install the STPS with two screws.
|
| 4. |
Install the front seat assembly. (Refer to BD group)
|
| 5. |
Reconnect the battery negative cable.
|
| 6. |
After installing the Seat Track Position Sensor, confirm proper
system operation:
Turn the ignition switch ON, the SRS indicator should be turned
on for about six seconds and then go off.
|
Seat Belt Buckle Switch (BS). Description and Operation
Description
The SRSCM shall monitor the status of the driver and front passenger seat
belt buckle. The SRSCM provides one pin each for the driver and front passenger
seat belt buckle status ...
See also:
Rear Repair procedures
Replacement
Rear Seat Belt Replacement
•
When installing the belt, make sure not to damaged the ...
Changing the coolant
Have coolant changed by an authorized HYUNDAI dealer according to the Maintenance
Schedule at the beginning of this section.
CAUTION
Put a thick cloth or fabric around the radiator cap before refi ...
Exterior care
Exterior general caution
It is very important to follow the label directions when using any chemical cleaner
or polish. Read all warning and caution statements that appear on the label.
Finish mai ...


