Hyundai Sonata: Seat Belt Buckle Switch (BS). Description and Operation
Description
The SRSCM shall monitor the status of the driver and front passenger seat
belt buckle. The SRSCM provides one pin each for the driver and front passenger
seat belt buckle status input. The seat belt buckle circuit operates from internal
boost voltage supplied by the SRSCM, and uses chassis ground for the signal
return. The buckle status shall modify the SRSCM deployment. If the buckle status
is unbuckled, the corresponding pretensioner will not be deactivated.
Seat Track Position Sensor (STPS). Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front seat asse ...
See also:
Delivery Pipe. Repair procedures
Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be in ...
Balance Shaft & Oil Pump. Repair procedures
Removal
1.
Remove the timing chain.
(Refer to Timing system in this group)
2.
Install a stopper pin (A) after compressing the balance
...
Heating and air conditioning
1. Start the engine.
2. Set the mode to the desired position. To improve the effectiveness of heating
and cooling :
- Heating:
- Cooling: 3. Set the temperature control to the desired position.
...
