Hyundai Sonata: Start/Stop Button. Repair procedures
Removal
| 1. |
Disconnect the negative(-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
| 3. |
Remove the crash pad center lower cover (A) after loosening the
mounting screws.
|
| 4. |
Remove the key set bezel (A) after loosening the mounting screw.
|
| 5. |
Disconnect the start/stop button connector (A).
|
| 6. |
Remove the start/stop button (A) by pushing the both sides of
the hooks.
|
Installation
| 1. |
Install the start/stop button.
|
| 2. |
Install the key set bezel.
|
| 3. |
Install the crash pad center lower cover.
|
| 4. |
Install the crash pad lower panel.
|
Start/Stop Button. Components and Components Location
Component
...
Fob Holder. Components and Components Location
Components
...
See also:
Interior Trim. Components and Components Location
Components
1. Front pillar trim
2. Center pillar upper trim
3. Center pillar lower trim
4. Rear pillar trim
5. Cowl side trim
6. Front door scuff trim
7. ...
Tightening Torque Table Of Standard Parts
Bolt nominal
diameter (mm)
Pich (mm)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
Head Mark 7
...
SRS Control Module (SRSCM). Repair procedures
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before b ...
